RADIOLINK ELETRONIC LIMITED
www.radiolink.com
Transmitter settings
1) Choose a 2-position switch to control CH8
2) Choose INITIAL SETUP on the top of the interface of MP
3) Click “FailSafe”in the pull-down menu of “ Madatory Harware” on the left and the interface of CH8 PWM
value is shown
4) Toggle the switch. If the PWM value of CH8 is more than 1800, it means the Alt-Hold function is enabled
when the switch is at the bottom position. If the PWM value of CH8 is less than 1800, it means the Alt-Hold
function is disabled when the switch is at the top position.
To Previous Page
Loading...