RADWAG WTC 2000 - 15. PERIPHERAL DEVICES; 15.1. Computer

- 26 -
Press „Finish” button.
Connect the scale to a computer
again, use 1.8-meter long USB
A
/B cable maximum. Respective
message box is displayed, press
OK button for confirmation.
„COM ports Screen”
automatically displays number of
installed COM port. In this very
case it is COM8.
2. Enter < P5.ducE / 5.1.PC / 5.1.1.Prt> submenu and set <USbb> value.
3. Run program for measurements readout.
4. Set communication parameters – select COM port that was installed in the
course of drivers installation (in this very case it is COM8).
5. Start cooperation.
15. PERIPHERAL DEVICES
<P5.ducE> menu contains list of devices cooperating with scale.