RADWAG WTC 2000 - 20. WORKING MODE - WEIGHING; 20.1. Local Settings

- 35 -
• Press key to confirm, next go to the home screen.
19.2.3. Automatic Printout Time Interval
Parameter enabling you to set frequency of automatic printout. Printout interval
is set in minutes with 1 [min] accuracy within 1 [min] - 1440 [min] range.
Procedure:
• Enter <P3.Func> menu and select given working mode.
• Enter <Int> function, window for entering time interval value is displayed.
• Press
key to confirm, next go to the home screen.
19.2.4. Lo Threshold
<Lo> parameter allows you to configure the function of automatic operation. In
order to save the next measurement, before carrying it out the mass indication
must get below the set net value of Lo threshold.
Procedure:
• Enter <P3.Func> menu and select given working mode.
• Enter <Lo> function, window for entering Lo threshold value is displayed.
• Enter respective value and press
key to confirm, then continue
weighing.
20. WORKING MODE – WEIGHING
<UUGG> is a standard working mode enabling you to carry out the weighing
operation along with record of the result to the database.
20.1. Local Settings
To go to local settings enter <3.1.UUGG> submenu.
3.1.1.Acc
Working mode accessibility
For detailed description read section 19.2.1.
3.1.2.Snn
Save mode
For detailed description read section 19.2.2.
3.1.3.Int
Time interval
For detailed description read section 19.2.3.
3.1.4.Lo
Lo threshold
For detailed description read section 19.2.4.