Rage SPINNER MISSILE XL

To Next Page

Nose Cone

Propeller

Stakes

Parachute

Compartment

Charging Port

LED’s

Function Button

Launch Pad

Flying the Spinner Missile X

Replacing Damaged Propellers

2. Place the Spinner Missile X on the launch pad. Press the launch button and the rocket will

4 seconds before the parachute opens. For the rocket to reach

NOTE: There is a 3 second delay from the time that the launch button is pressed and the Spinner

Missile X begins its launch. This allows time to walk a safe distance away from the missile.

Loading the Parachute

1. Check for any entanglement of the parachute chords, untangle if necessary.

2. Fold the bottom of the parachute over so it touches the base of the nose cone.

3. Push the release piston down, then carefully insert the parachute chords and folded

parachute into the compartment.

4. Push the nose cone down onto the compartment. Check that none of the parachute fabric

is stuck between the nose cone and the parachute compartment.

The Spinner Missile X features a parachute to reduce the impact during landings. Loading the

parachute correctly will reduce the possibility of a malfunctioning parachute.

To replace a damaged propeller, remove the screw holding it in place and slide the propeller

screw. If you are not able to remove the old propeller by hand, use pliers to assist.

Warning:

To avoid injury and damage, check the propeller

regularly for nicks and breaks and make sure it is

Use only the propeller intended for this product

Part# RGR4138.

Do not alter, repair, modify or customize the propellers

The Spinner Missile X includes an internal Lithium battery.

Never place or store this product in a hot location.

Keep the product in dry and cool environment at all times.

Use only the included USB cable to charge the Spinner Missile X

Charge the battery per instructions in this manual only.

Do not damage or puncture the Lithium battery.

Charge the Lithium battery every 6 months for maximum service life.

directly at www.ragerc.com or call 1-800-622-7223 M-F 9:00-5:00PM Mountain Time

Item number Description

RGR4131 Spinner Missile X Electric Free-Flight Rocket

RGR4137 500mA USB Charger; Spinner Missile X

RGR4138 Propeller; Spinner Missile X

NOTE:

Missile X look for a location that

is free of trees or other obstructions

that the missile might get caught

landing spots like grass whenever

possible.

Before launching, observe the wind

direction. The Spinner Missile X will

drift downwind during its descent.

Check that there are no obstructions

in the downwind direction.

If any repairs to the foam are necessary,

use a sutiable foam-safe CA adhesive (Super Glue).

Make sure that the lines or

chute are not pinched by

the nose cone.

Make sure that the lines are

not twisted or tangled.

Lithium Battery Warning

Replacement Parts

its highest altitude

Packaging Contents: Missile USB Charging Cable Launch Pad & Stakes

Warranty

Warranty Period: Rage warrants that the Spinner Missile XL (”product”) will be free from

origInal factory defects in materials and workmanship upon purchase (”Warranty Period”).

What is Not Covered - This warranty is not transferable and does not cover (a) cosmetic

damage, (b) damage due to act of God, assident, misuse, abuse, neglegence, commercial

use, or due to improper use, installation, operation or maintenance, (c) modication to any

part of the Product, (d) attempted service by enyone other than a Rage authorized service

center, or (e) Product not purchased from an authorized Rage dealer.

OTHER THAN THE EXPRESS WARRANTY ABOVE, RAGE MAKES NO OTHER WARRANTY OR

REPRESENTATION, AND THEREFORE DISCLAIMS ANY AND ALL IMPLIED WARRANTIES,

INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF NON-INFRINGMENT,

MERCHANTABILITIES AND SUITABILITY FOR A PERTICULAR PURPOSE. THE PURCHASER

ACKNOWLEDGES THAT THEY ALONE HAVE DETERMINED THAT THE PRODUCT WILL MEET

THE REQUIREMENTS OF THEIR INTENDED USE.

Purchaser’s Remedy - Rage’s sole obligation and purchaser’s sole and exclusive remedy

shall be that Rage will, at it’s option, either (a) service, or (b) replace, any Product

determined by Rage to be defective. Rage reseves the right to inspect any and all Product(s)

involved in a warranty claim. Service or replacement decisions are at the sole discretion of

Rage. Proof of purchase is required for all warranty claims.

SERVICE OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE PURCHASERS

SOLE AND EXCLUSIVE REMEDY.

Limitations of Liability -

RAGE SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL

OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS, OR PRODUCTION OR COMMERCIAL

LOSS IN ANY WAY, REGARDLESS OF WHETHER SUCH CLAIM IS BASED IN CONTRACT,

WARRANTY, TORT, NEGLIGENCE, STRICT LIABILITY OR ANY OTHER THEORY OF LIABILITY,

EVEN IF RAGE HAS BEEN ADVISED OF THE POSSABILITY OF SUCH DAMAGES.

Further, in no event shall the liability of Rage exceed the individual price of the Product on

which liability is asserted. as Rage has no control over use, setup, nal assembly,

modication or misuse, no liability shall be assumed nor accepted for any resulting damage

or injury. By the act of use, setup or assembly, the user accepts all resulting liability. If you ,

as the purchaser or user, are not prepared to accept the liability associated with the use of

the Product, purchaser is advised to return the Product immediately in new and unused

condition to the place of purchase.

Law - These terms are governed by Utah law (without regard to conict of law principals).

This warranty gives you specic legal rights, and you may also have other rights which vary

from state to state. Rage reserves the right to change or modify this warranty at any time

without notice.

Rage, an exclusive brand of:

HRP Distributing, Inc.

2034 South 3850 West

Salt Lake City, Utah 84104

©HRP Distributing, Inc.

Printed in China

4 1

Specication

Motor Run Time 1 Press – 7 sec

2 Press – 9 sec

3 Press – 12 sec

Flying height: Over 150ft (50m)

With 3 presses

Launches per Charge: Up to 20

Internal Battery: 3.7V 300mAh

LiPo Charging time: 40 minutes

Height: 10.7” (272mm)

Weight: 2.1 oz. (59.5g)

Prop: 6” weighted (152.4mm)

SAFETY WARNINGS:

• All of the safety and operating instructions should be read, adhered

to and followed before the unit is operated.

•To avoid injury, do not touch the product while ying or the propeller

while moving.

•Be careful to keep your body and any loose clothing away from the

moving propellor.

• Do not modify or change this product without authorization

Charging Instructions:

1. Connect the included USB charge cord to the port located on the back side of the rocket

and the USB connector to a power source, such as a laptop.

Charge time is about 40 minutes.

2. The main indicator light on the front of the rocket will be red during charging and will turn

off when the charge is complete.

CAUTION:

Use only the included USB

charger to charge the

Spinner MIssile XL battery.

Other chargers may damage

this product.

INSTRUCTIONS

Printed 06/22

Up to 40

Up to 150’ (50m)

3.7V 250mAh LiPo

30 Minutes

1.7 oz. (49g)

Power LED

Nose Cone

Parachute Compartment

Launch Button

Weighted Propeller

Launch Pad

Charging Port

Launch Pad

Missile USB Charging Cable

Instruction Manual

Motor Run Time

Flights Per Charge

Flying Height

Internal Battery

Charge Time

Missile Weight

Missile Height

9” (228mm)

1. Connect the included USB charger to the charge port on the Spinner Missile X and a USB power

source, such as a laptop. The indicator light on the USB charger will be red during charging and

turn o when the battery is fully charged. Charge time is about 30 minutes.

2. Disconnect the USB charger when the battery is fully charged. Do not attempt to over charge!

CAUTION:

Use only the included USB

charger to charge the

Spinner Missile X battery.

Other chargers may damage

the product!

1 Press = 4 Sec

2 Press = 8 Sec

Specications

Package Contents:

Charging Instructions:

Need help?

Do you have a question about the Rage SPINNER MISSILE XL and is the answer not in the manual?

The Spinner Missile XL is a recreational flying device designed for outdoor use, featuring a parachute recovery system for gentle landings. It is an exclusive brand of HRP Distributing, Inc., manufactured in China.

Function Description

The Spinner Missile XL is a rocket-like device that launches into the air and then deploys a parachute for a controlled descent. It is operated using a single function button, which controls the motor run time and, consequently, the flying height. The device is designed to be launched from an included launch pad with stakes, ensuring stability during takeoff. After launch, the motor spins a propeller to generate thrust, and at the end of the flight time, the propeller stops, and a parachute is deployed to bring the rocket back to the ground safely. The device includes LED indicators for various statuses, such as power on, charging, and flight readiness.

Important Technical Specifications

Motor Run Time:
- 1 Press: 7 seconds
- 2 Presses: 9 seconds
- 3 Presses: 12 seconds
Flying Height: Over 150 feet (50 meters) with 3 presses
Launches per Charge: Up to 20
Internal Battery: 3.7V 300mAh LiPo
LiPo Charging Time: Approximately 40 minutes
Height: 10.7 inches (272 mm)
Weight: 2.1 ounces (59.5 g)
Propeller: 6-inch weighted (152.4 mm)
Components: Nose Cone, Parachute Compartment, Function Button, Charging Port, LEDs, Propeller, Launch Pad, Stakes.

Usage Features

Charging:

Connect the included USB charge cord to the port on the back of the rocket and the USB connector to a power source (e.g., laptop).
The main indicator light on the front of the rocket will be red during charging and will turn off when charging is complete.
Charge time is approximately 40 minutes.
Caution: Use only the included USB charger to charge the Spinner Missile XL battery. Other chargers may damage the product.

Operating Instructions:

Place the base of the rocket on the shaft at the center of the launch pad so that it is standing upright.
Press the Function Button to turn the unit on. The red LED will be lit when the unit is on.
Short press the Function Button again for flight time selection:
- One press for 7 seconds
- Two for 9 seconds
- Three for 12 seconds
After the flight time is selected, the propeller will begin to slowly spin, and the yellow LED will turn on. This indicates the device is ready to move away from the rocket before it launches.
About 5 seconds after the propeller starts spinning, the LEDs will switch from yellow to green, and the prop begins to accelerate for launch. During flight, all LEDs on the unit will be on.
When the motor stops at the apex, the parachute will release, and the rocket will slowly descend to the ground. Only the red LED will remain on as a power indicator.
To launch again, return to Step 1 of the instructions.
When finished with flights, press and hold the Function Button until the red power indicator LED turns off.

Loading the Parachute: The Spinner Missile XL features a parachute to reduce the impact during landing. Proper loading is crucial for reliable deployment.

Check for any entanglement of the parachute cords and untangle if necessary.
Fold the bottom of the parachute over so it touches the base of the nose cone.
Push the release piston down, then carefully insert the parachute cords and folded parachute into the compartment.
Push the nose cone down onto the compartment. Ensure that none of the parachute fabric is stuck between the nose cone and the parachute compartment.
Make sure that neither the cords nor the fabric are pinched by the nose cone.
Make sure that the lines are not twisted or tangled.
For a more stable launch, install the included stakes as shown into a dirt or grass launch site.

Safety Warnings:

Read, adhere to, and follow all safety and operating instructions before use.
To avoid injury, do not touch the product while flying or the propeller while moving.
Keep your body and any loose clothing away from the moving propeller.
Do not modify or change this product without authorization.
Important: Observe the wind direction. The Spinner Missile XL will drift according to wind direction during its descent, so make sure you find a location that is free of trees or other obstructions that the rocket may get caught up in as it lands. For best results, make sure you have a clear space of at least 50 yards on all sides and avoid launching in winds that are more than 5 to 10mph.
To avoid damage to the rocket, choose soft landing spots like grass whenever possible. If any repairs to the foam are necessary, use a suitable foam-safe CA adhesive, like Super Glue.

Maintenance Features

Lithium Battery Warnings:

The Spinner Missile XL includes an internal Lithium battery.
Do not dispose of the Spinner Missile XL with battery in a fire.
Never place or store this product in a hot location.
Keep the product in a dry and cool environment at all times.
Use only the included USB charge cord to charge the Spinner Missile XL.
Charge the battery per instructions in this manual only.
Do not damage or puncture the Lithium battery.
Charge the Lithium battery every 6 months for maximum service life.

Replacing Damaged Propellers: To replace a damaged propeller, remove the screw holding it in place and slide the propeller away from the rocket and off the shaft. Slide the new propeller into position and reinstall the screw. If you are not able to remove the old propeller by hand, use pliers, as needed.

Warning: To avoid injury and damage, check the propeller regularly for nicks and breaks and make sure it is securely attached before and after each flight.
Use only the propeller intended for this product (Part# RGR4155).
Do not alter, repair, modify, or customize the propellers.

Replacement Parts: See your local hobby shop or place of purchase first. If unavailable, parts can be ordered directly at www.ragerc.com or call 1-866-724-3811 M-F 8:00AM-5:00PM Mountain Time.

Part Number RGR4155: Propeller
Part Number RGR4156: 600mA USB Charge Cable
Part Number RGR4157: Launch Pad w/ Stakes

Warranty: Rage warrants the Spinner Missile XL to be free from original factory defects in materials and workmanship for the Warranty Period.

What is Not Covered: Cosmetic damage, damage due to acts of God, accident, misuse, abuse, negligence, commercial use, improper use, installation, operation or maintenance, modification to any part, attempted service by unauthorized personnel, or products not purchased from an authorized Rage dealer.
Purchaser's Remedy: Rage's sole obligation is to service or replace any defective product at its option. Proof of purchase is required.
Limitations of Liability: Rage is not liable for special, indirect, incidental, or consequential damages, loss of profits, or production or commercial loss. Liability will not exceed the individual price of the product. By using the product, the user accepts all resulting liability. If not prepared to accept liability, return the product immediately in new and unused condition.
Law: Governed by Utah law. Rage reserves the right to change or modify this warranty without notice.

Warning: CHOKING HAZARD—Small Parts Not For Children Under 3 Years.