1. Establish position of closures.
2. A mounting gauge can be made as an additional aid.
General mounting instructions for closures
4.Mount closures and screws, made sure components (e.g. blocks to closure)
are parallel.
3. Choose fixings which are suitable for the base material.
The bearing surface for the hinges on the doorframe and
door must be sufficiently strong.
Caution
if elements not parallel
- occurrence of noise
- increased wear
- broken seal
5. Make sure there is the same distance between door and frame all round!
correct
incorrect
incorrect
Illustrations and texts are without obligation. We reserve the right for technical modifications due to new legal requirements or errors. 01.03
To Next Page
General