1. Before turning on, fill up the section
pipe and pump with water and then
start the pump by connecting the
regulator power plug to a current
outlet; when the pump stops open the
tap situated higher up.
2. Installation is correct if the flow from
the tap is regular and if the pump
works continuously if there is no water
you can try to make the pump work
‘without interruption — for a period of
time longer than the device’s working
time - by keeping the RESTART button
depressed. If the problem persists,
disconnect the regulator and repeat the
procedure from point 1.
Dry stop: The red ALARM LED lits up
with motor off to indicate a dry stop. To
start the system again press the
RESTART button after having checked
the presence of water in the suction
pipe.
SAFETY INSTRUCTIONS
When using electric tools, the following
basic safety precautions should always
be followed to reduce the risk of fire,
electric shock and personal injury.
Read all these instructions
before attempting to operate this
product. Save these instructions.
1. Check voltage indicated on
nameplate;
2. Keep work area clean
Cluttered areas and benches invite
injuries;
3. Consider work area environment
Do not expose power tools to rain.
Do not use power tools in damp or wet
locations. Keep work area well lit. Do
not use power tools in presence of
flammable liquids or gasses;
4. Guard against electric shock
Avoid body contact with earthed
surfaces (e.g. pipes, radiators, ranges,
refrigerators);
5. Keep children away
Do not let visitors contact tool or cord;
they should be kept away from work
area;
6. Store idle tools
When not in use, tools should be
stored in a dry and locked-up place,
out of reach of children;
7. Do not force the tool
It will do the job better and safer at the
rate for which it was intended;
8. Use the right tool
Do not force small tools or attachments
to do the job of a heavy-duty tool. Do
not use tools for purposes not intended
(e.g. do not use a circular saw for
cutting tree limbs or logs);
9. Dress properly
Do not wear loose clothing or jewelry;
they can be caught in moving parts.
Rubber gloves and non-skid footwear
are recommended when working
outdoors. Wear protective hair
covering to contain long hair;
10. Use safety glasses
Also use face or dust mask, if cutting
operation is dusty;
11. Connect dust extraction
equipment
If devices are provided for the
connection of dust extraction and
collection facilities, ensure these are
connected and properly used;
12. Do not abuse the cord
Never carry the tool by the cord, never
yank the cord to disconnect it from the
To Next Page
Loading...
