Raisecom Gazelle S1020i-GL Series - Fiber; Table 2-34 Type and Usage of the Fiber

Raisecom
Gazelle S1020i-GL (A) User Manual
2 Hardware structure
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
40
2.7.6 Fiber
Introduction
The Gazelle S1020i-GL supports the Single-Mode Fiber (SMF) and Multi-Mode Fiber
(MMF). These two kinds of fiber are the same in appearance but different in color. The
yellow one is the SMF and the orange one is the MMF.
The Gazelle S1020i-GL can be connected to the Optical Distribution Frame (ODF) or optical
interfaces of other devices through fiber.
Table 2-34 lists the type and usage of the fiber.
Table 2-34 Type and usage of the fiber
Usage
Local
connector
Remote
connector
Type
Standard

Connect the Gazelle
S1020i-GL to the ODF
through the Ethernet
optical interface.

Connect the Ethernet
optical interface on the
Gazelle S1020i-GL to
optical interfaces on
other devices.
LC/PC
LC/PC
2-mm SMF
ITU-T
G.652
2-mm MMF
LC/PC
FC/PC
2-mm SMF
2-mm MMF
LC/PC
SC/PC
2-mm SMF
2-mm MMF

Choose the connector type and jumper cable length reasonably based on the on-
site requirements.

Choose a connector suitable for the optical interface. Otherwise, it may increase
additional loss of fiber links, reduce transmission quality of services, or even
damage the connector and optical interface.
Appearance
Figure 2-32 shows the appearance of the LC/PC fiber connector.