Raisecom ISCOM2600G-HI (A) Series - Configuring Ethernet CSF; Configuring Performance Monitoring; Checking Configurations

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
9 OAM
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
381
Step
Command
Description
3
Raisecom(config-
service)#service suppress-
alarms enable mep { mep-id
| all }
Enable alarm suppression.
By default, this function is enabled.
9.3.10 Configuring Ethernet CSF
Configure the Ethernet Client Signal Fail (CSF) for the ISCOM2600G-HI series switch as
below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#serv
ice csi-id level ma-
level
Enter service instance configuration mode.
3
Raisecom(config-
service)#service csf
enable mpid mep-id
Enable the function of sending CSF packets.
By default, this function is disabled.
4
Raisecom(config-
service)#service csf
period { 1 | 60 }
Configure the period for sending CSF packets. By
default, the period for sending CSF packets is 1s.
5
Raisecom(config-
service)#service csf
trap enable
Enable the function of sending CSF Traps
upstream. This function is applicable to PW
OAM only.
By default, this function is disabled.
9.3.11 Configuring performance monitoring
Configure the performance monitoring for the ISCOM2600G-HI series switch as below.
Step
Command
Description
1
Raisecom#config
Enter global configuration mode.
2
Raisecom(config)#service
csi-id level ma-level
Enter service instance configuration mode.
3
Raisecom(config-
service)#service pm enable
mep { all | mep-id }
Enable MEP performance monitoring.
9.3.12 Checking configurations
Use the following commands to check configuration results.