IN CASE OF EMERGENCY 357
Front Jacking Location
When changing the front wheel, assemble the jack
driver to the jack and connect the jack driver to the
extension tubes. Place the jack under the axle as
close to the tire as possible with the drive tubes ex-
tending to the front. Connect the extension tubes and
lug wrench.
Front Lifting Point
Front Jacking Location
Rear Jacking Location
When changing a rear wheel, assemble the jack driv-
er to the jack and connect the jack driver to the exten-
sion tubes. Place the jack under the axle between the
spring and the shock absorber with the extension
tubes extending to the rear.
Rear Lifting Point
Rear Jacking Location
4. Connect the extension tubes and lug wrench.
5. By rotating the lug wrench clockwise, raise the vehicle
until the wheel just clears the surface.
CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in the Jacking
Instructions for this vehicle.
CAUTION!
Before raising the wheel off the ground, make sure that
the jack will not damage surrounding truck parts and
adjust the jack position as required.
WARNING!
Raising the vehicle higher than necessary can make the
vehicle less stable. It could slip off the jack and hurt
someone near it. Raise the vehicle only enough to
remove the tire.
7
23_DJD2_OM_EN_USC_t.book Page 357
To Next Page
Loading...
