TURN SIGNALS/HEADLIGHTS/HIGH BEAMS LEVER
Turn Signals/Lane Change Assist
• Tap the lever up or down once and the turn signal (right or left) will flash three
times and automatically turn off.
Headlights/Parking Lights
• The ignition switch must be in the ON/RUN position for the headlights to operate.
• Rotate the end of the lever to the first detent for parking lights and headlight
operation.
High Beam Operation
• Pull the multifunction lever toward you to switch the headlights to high beam.
• Pull the multifunction lever a second time to switch the headlights back to low
beam.
•
A high beam symbol will illuminate in the cluster to indicate the high beams are on.
NOTE:
For safe driving, turn off the high beams when oncoming traffic is present to prevent
headlight glare and as a courtesy to other motorists.
1 — High Beams
2 — Headlights
3 — Turn Signals
OPERATING YOUR VEHICLE
17
To Next Page
Loading...
