OM-FX SERIES 7
Operation
THE FX-1 SERIES UNIT IS DESIGNED TO
OPERATE IN EITHER REFRIGERATOR OR
FREEZER. FACTORY DEFAULT SETTING IS
FOR FREEZER MODE AND SET AT -3ºF.
Allow unit to operate for approximately two (2) hours before placing in food.
AMBIENT CONDITIONS
Unit is designed for normal operating temperatures are between 70-100°F. Operating
outside of those temperatures may cause premature product wear or failure
Randell has attempted to preset the temperature control to ensure that your unit runs at an
optimum temperature, but due to varying ambient conditions, including elevation, food type
and your type of operation, you may need to alter this temperature using control adjustment
until desired temperature is reached.
DANFOSS CONTROLLER OPERATION
LED FUNCTION
Compressor energized & Evaporator fan de-energized
Defrost in progress
Fans delay after defrost completion
Evaporator fan energize
An alarm is occurring
ºC / ºF Temperature unit
POWER ON / OFF: Press and hold the power button until LED display turns On / Off
MANUAL DEFROST: Press and hold “Defrost” Button
CHANGE SET POINT: To raise temperature
1. Press and hold “
” to access set point.
2. When set point start ashing, Press “
” to adjust set point
3. After 30 seconds, the display automatically reverts to showing the current temperature
CHANGE SET POINT: To lower temperature
1. Press and hold “v” to access set point
2. When set point start ashing, Press “v” to adjust set point
3. After 30 seconds, the display automatically reverts to showing the current temperature
POWER ON / OFF
MANUAL DEFROST
CHANGE SET POINT
To Next Page
Loading...
Need help?
General
