OM-FX SERIES 9
Maintenance
Randell strongly suggests a preventive maintenance program which would include the
following Monthly procedures:
1. Clean fan blades on the condensing unit and evaporator assembly.
2. Clean all gaskets on a weekly if not daily basis with a solution of warm water and a mild
detergent to extend gasket life.
3. Lubricate door hinges with lithium grease. Modify for FX drawer slides and verify with
engineering
RECOMMENDED CLEANERS FOR YOUR STAINLESS STEEL INCLUDE THE FOLLOWING:
JOB CLEANING AGENT COMMENTS
Routine cleaning
Soap, ammonia,
detergent Medallion
Apply with a sponge or cloth
Fingerprints and smears Arcal 20, Lac-O-Nu, Ecoshine Provides a barrier lm
Stubborn stains and
discoloration
Cameo, Talc, Zud,
First Impression
Rub in the direction of the polish
lines
Greasy and fatty acids, blood,
burnt-on foods
Easy-Off, Degrease It,
Oven Aid
Excellent removal on all nishes
Grease and Oil Any good commercial detergent Apply with a sponge or cloth
Restoration/Preservation Benet, Super Sheen Good idea monthly
Reference: Nickel Development Institute, Diversey Lever, Savin, Ecolab, NAFEM
Proper maintenance of equipment is the ultimate necessity in preventing costly repairs. By
evaluating each unit on a regular schedule, you can often catch and repair minor problems
before they completely disable the unit and become burdensome on your entire operation.
For more information on preventive maintenance, consult your local service
company or CFESA member. Most repair companies offer this service at very reasonable
rates to allow you the time you need to run your business along with the peace of mind that all
your equipment will last throughout its expected life. These services often offer guarantees as
well as the exibility in scheduling or maintenance for your convenience.For a complete listing
of current Randell ASA please visit www.uniedbrands.net.
Randell believes strongly in the products it manufactures and backs those products with one of
the best warranties in the industry. We believe with the proper maintenance and use, you will
realize a protable return on your investment and years of satised service.
DO NOT USE SHARP UTENSILS AND/OR
OBJECTS.
CAUTION
DO NOT USE ABRASIVE CLEANING
SOLVENTS, AND NEVER USE HYDROCHLORIC
ACID (MURIATIC ACID) ON STAINLESS STEEL.
DO NOT USE STEEL PADS, WIRE BRUSHES,
SCRAPERS, OR CHLORIDE CLEANERS TO
CLEAN YOUR STAINLESS STEEL.
DO NOT PRESSURE WASH EQUIPMENT AS
DAMAGE TO ELECTRICAL COMPONENTS
MAY RESULT.
To Next Page
Loading...
Need help?
General
