SENSe Subsystem :DETector EM510
5.69 4065.7763.32-01.00
. . :STEReo[:STATe] 1|0|ON|OFF
Switching on/off the stereo decoder.
Parameters:
1|ON switching on the stereo decoder
0|OFF switching off the stereo decoder
Example:
FM:STEReo ON
. . :STEReo[:STATe]?
Query about the state of the stereo decoder.
Parameters:
none
Example:
FM:STEReo? 1
Notes:
The RDS decoder and the stereo decoder work only with FM demodulation. The bandwidth must be
> = 120 kHz and <= 250 kHz.
The detector flags work only when the detector is working (see also the description of the SCPI
commands FM:RDS:DATA? on page 5.67).
Stereo flag : stereo decoder must be switched on
ARI/RDS flag: RDS decoder must be switched on
If the stereo decoder detects the stereo pilot tone then it automatically switches the audio output over
onto two-channel stereo. The stereo information in the RDS field DI is then independent of the stereo
code in the flags field.
For the testing of the RDS-functionality there is a web page within the device. This page can be called
up via <IP address>/rds.html.
To Next Page
Loading...
