R&S EM510 - Page 107

SENSe Subsystem:FREQuency EM510
5.71 4065.7763.32-01.00
. . [:CW|FIXed]? [MINimum|MAXimum]
Query about the receiver frequency.
Parameters:
none query about the current receiver frequency
MINimum|MAXimum query about the lowest|highest receiver frequency
Result:
Frequency value in Hz
Example:
FREQuency? -> 801000
. . :MODE CW|FIXed|SWEep|MSCan|PSCan
Changing the operating mode of the receiver.
Parameters:
CW | FIXed receiver monitors a frequency (CW and FIXed have equal
meanings)
SWEep receiver is in frequency-scan mode (see SENSe:SWEep)
MSCan receiver is in memory-scan mode (see SENSe:MSCan)
PSCan receiver is in panorama-scan mode (see SENSe:PSCan)
Note:
The receiver stays on the CW frequency until it starts scanning!
*RST state
CW
Example:
FREQuency : MODE SWEep
. . :MODE?
Query about the receiver operating mode.
Parameters:
none
Result:
CW, SWE, MSC, PSC
Example:
FREQuency:MODE? -> SWE