R&S EM510 - Page 133

SENSe Subsystem :SWEep EM510
5.97 4065.7763.32-01.00
. . . :TIME? [MINimum|MAXimum]
Query about the hold time during signal-controlled scan continuation.
Parameters:
none query about the current hold time
MINimum|MAXimum query about the lowest|highest hold time
Result:
Hold time in seconds
Example:
SWEep:HOLD:TIME? 0.010
. . :STEP<numeric_value>|MINimum|MAXimum
Setting the frequency stepwidth for the frequency scan.
Parameters:
<numeric_value> frequency value
MINimum|MAXimum sets the smallest/biggest frequency stepwidth
*RST state:
1 kHz
Example:
SWEep:STEP 25 kHz
. . :STEP? [MINimum|MAXimum]
Query about the frequency stepwidth of a frequency scan
Parameters:
none query about the current frequency stepwidth
MINimum|MAXimum query about the smallest|largest frequency stepwidth
Result:
Stepwidth in Hz
Example:
SWEep:STEP? -> 25000