R&S EM510 - Page 136

EM510 STATus Subsystem
4065.7763.32-01.00 5.100
Exemplifying all STATus register commands, for example the STATus:OPERation:SWEeping register,
the commands of the STATus:OPERation register are explained as follows.
STATus
. OPERation
. . :CONDition?
Query about the condition section of the OPERation status register.
Parameters:
none
Result:
Depending on the setting by the FORMat:SREGister command, the contents of the register are
transferred as a decimal, binary or hexadecimal value in the ASCII code.
Example:
STATus:OPERation:CONDition? -> #H0008
. . :ENABle <numeric_value>
Setting the enable section of the OPERation status register.
Parameters:
<numeric_value> value of the enable section (0..65535 or #H0000..#HFFFF
or #B0..#B1111111111111111)
*RST state:
will not be changed by *RST
Example:
STATus:OPERation:ENABle #H0008
. . :ENABle?
Query about the enable section of the OPERation status register.
Parameters:
none
Result:
Depending on the setting by the FORMat:SREGister command, the contents of the register are
transferred decimally, binary or hexadecimally in the ASCII code.
Example:
STATus:OPERation:ENABle? -> #H0008