EM510 TRACe Subsystem
4065.7763.32-01.00 5.118
The following is valid for the IFPAN trace:
Output of the spectrum data. If there are no data available then a NaN (Not a Number) will be output.
The output format of the IFPAN trace depends on the settings made by command FORMat:DATA.
ASCii -> normal ASCII output:
level in dBV
PACKed -> <Definite Length Block>:
level in 1/10 dBV (2 bytes)
The following is valid for the suppress trace:
List of frequencies contained in the trace. The suppress-trace output format is defined according to the
relevant setting through command FORMat:DATA:
ASCii ->Normal ASCII output:
list of frequencies in Hz
PACKed -> <Definite Length Block>
list of frequencies in Hz, 4 bytes per frequency
Example:
TRACE? SSTART -> 123475, 118000, 98550
To Next Page
Loading...
