EM510 DISPlay Subsystem
4065.7763.32-01.00 5.28
5.3.7 DISPlay Subsystem
DISPlay
. :MENU[:NAME] <menu_name>
Selection of a specific data channel for the video panorama display from the pre-set list. In addition to
the channel, this sets the pre-conditioning of the selected time signal. Please note that the
demodulation mode should correspond to the channel selection and pre-conditioning. The table below
identifies some plausible combinations. See also command SYSTem:VIDeo:REMote:MODE.
Data channel selection
Demodulation modes AM FM AMSQ FMSQ IQ IQSQ
AM, FM, PULSE, PM X X X X
IQ, ISB, CW, LSB, USB X X X X X X
Parameters:
<menu_name> OFF no video panorama data
DEFault no video panorama data
LEFT left / AM channel / I channel of the video panorama data
AM left / AM channel / I channel of the video panorama data
RIGHt right / FM channel / Q channel of the video panorama data
FM right / FM channel / Q channel of the video panorama data
IQ video IQ panorama data
AMSQuare squared AM channel / I channel of the video panorama data
FMSQuare squared FM channel / Q channel of the video panorama data
IQSQuare squared video IQ panorama data
*RST state:
OFF
Example:
DISPlay:MENU LEFT
. :MENU[:NAME]?
Query about a specific data channel that was selected for the video panorama display.
Parameters:
none
Result:
<menu_name> OFF no video panorama data
LEFT left / AM channel / I channel of the video panorama data
RIGHt right / FM channel / Q channel of the video panorama data
IQ video IQ panorama data
AMSQ squared AM channel / I channel of the video panorama data
FMSQ squared FM channel / Q channel of the video panorama data
IQSQ squared video IQ panorama data
Example:
DISPlay:MENU? -> LEFT
To Next Page
Loading...
