R&S EM510 - OUTPut Subsystem: Signal Output Control

EM510 OUTPut Subsystem
4065.7763.32-01.00 5.46
5.3.13 OUTPut Subsystem
OUTPut
. :AUXMode FREQuency|ANTCtrl
The switch "AUXMode" determines whether the frequency in BCD or the antenna number in BCD and
the CTRL byte are output via X12b at the front panel.
Parameters:
FREQuency frequency output at "AUX"
4-digit BCD (10, 100 kHz, 1 MHz, 10 MHz)
ANTCtrl output of antenna number in 2-digit BCD (ANTA1 to ANTA80)
output of CTRL byte, binary (CTRL1 to CTRL8)
*RST state:
ANTCtrl
Example:
OUTPut:AUXMode FREQuency
. :AUXMode?
Query about the "AUXMode" setting.
Parameters:
none
Result:
FREQuency (frequency output) or ANTCtrl (output of antenna number and CTRL byte)
Example:
OUTPut:AUXMode?  FREQuency