R&S EM510 - Page 87

OUTPut Subsystem EM510
5.51 4065.7763.32-01.00
. . :CONTrol MEMory|NONE
Selection of the source for the operating state after switching the unit on, when reading the memory
locations by the MEMory:COPY command, when using the RCL key or when running memory scan.
Parameters:
MEMory squelch state and squelch value are read out of the memory
locations
NONE squelch state and squelch value are not read out of the memory
locations
*RST state
MEMory
Example:
OUTPut:SQUelch:CONTrol NONE
. . :CONTrol?
Query about the source of squelch setting when reading memory locations.
Parameters:
none
Result:
MEM, NONE
Example:
OUTPut : SQUelch : CONTrol?  MEM