R&S ESU Instrument Functions
Basic Settings
4.286 Operating Manual 1302.6163.12 - 03
CONFIGURE
NETWORK
The CONFIGURE NETWORK softkey opens the following submenu:
COMPUTER
NAME
The COMPUTERNAME softkey opens a dialog to enter the computer name. The
naming conventions of Windows apply.
For more details see the Quick Start Guide 6, “ LAN Interface”.
IP ADDRESS The IP ADDRESS softkey opens a dialog to configure the instrument's IP address.
The TCP/IP protocol is preinstalled with the IP address 10.0.0.10. If the DHCP
server is available (DHCP ON) the softkey is not available.
For more details see the Quick Start Guide 6, “ LAN Interface”.
SUBNET MASK The SUBNET MASK softkey opens a dialog to configure the instrument's TCP/IP
subnet mask. The TCP/IP protocol is preinstalled with the subnet mask
255.255.255.0.
The subnet mask consists of four number blocks separated by dots. Each block con-
tain 3 numbers in maximum (e.g.100.100.100.100), but also one ore two numbers
are allowed in a block (as an example see the preinstalled address).
For more details see the Quick Start Guide 6, “ LAN Interface”.
DHCP ON | OFF If the DHCP softkey is set ON, a new IP address is assigned each time the instru-
ment is restarted. This address must first be determined on the instrument itself.
COMPUTER NAME
IP ADDRESS
SUBNET MASK
DHCP ON | OFF
CONFIGURE
NETWORK
SHOW CONFIG
The Network Configuration softkeys above are available from firmware Version
4.3x.
Instruments shipped with Windows XP Service Pack1 require an additional instal-
lation package (LXI installer) if the softkeys are not visible. This installation pack-
age is available on the R&S instrument's download area.
The configuration via softkeys is only possible if the LAN is connected to the
instrument.
To avoid problems, use a fixed IP address.
Using a DHCP server is not suitable for remote operation of the R&S FSU.
To Next Page
Loading...
