R&S ESU Series - Page 331

R&S ESU Instrument Functions
Basic Settings
4.300 Operating Manual 1302.6163.12 - 03
For details on storing and loading instrument settings refer to the Quick Start Guide,
chapter “ Storing and Loading Instrument Settings”.
SAVE |
RECALL
The SAVE softkey opens the Save dialog box for entering the data set to be stored.
The RECALL softkey activates the Recall dialog box to enter the data set to be
loaded. The RECALL table shows the current settings regarding the data set.
The entries are edited with the rotary knob or the CURSOR UP / DOWN key and is
confirmed by pressing the rotary knob or the ENTER key.
Subdirectories are opened by the CURSOR RIGHT Ur key and closed with the
CURSOR LEFT Ul key.
In the Save dialog box, the field already contains a suggestion for a new name: the
file name used in the last saving process is counted up to the next unused name.
For example, if the name last used was "test_004", the new name "test_005" is sug-
gested, but only if this name is not in use. If the name "test_005" is already in use,
the next free name is suggested, e.g. "test_006". You can change the suggested
name to any name conform to the following naming conventions.
The name of a settings file consists of a base name followed by an underscore and
three numbers, e.g. "limit_lines_005". In the example, the base name is "limit_lines".
The base name can contain characters, numbers and underscores. The file exten-
sion is added automatically and can not be changed.
The SAVE / RECALL table contains the entry fields for editing the data set.
Remote command: MMEM:STOR:STAT 1,"f:\test02"
MMEM:LOAD:STAT 1,"f:\test02"
SAVE FILE The SAVE FILE softkey sets the focus on the File Name field to enter a conforming
file name.
RECALL FILE The RECALL FILE softkey sets the focus on the Files field to choose a stored file to
restore.
SELECT PATH The SELECT PATH softkey sets the focus on the Path field and opens the pull-down
list to choose the correct path to store the file.
SELECT FILE The SELECT FILE softkey sets the focus on the Files field to choose a already
stored file. In addition, the DELETE softkey is displayed. The list Files lists all data
sets which are stored in the selected directory.
Remote command: --
Path Directory in which the data set is stored.
Files List of data sets already stored.
File Name Name of data set.
The name can be entered with or without drive name and directory; the
drive name and directory, if available, will then appear in the Path field.
The extension of the data name is ignored.
Comment Comment regarding the data set.
Items Selection of settings to be stored/loaded.