R&S ESU Instrument Functions
Basic Settings
4.302 Operating Manual 1302.6163.12 - 03
The Save dialog box offers the following selectable data subsets in the Items field.
SELECT ITEMS The SELECT ITEMS softkey sets the focus on the Items field to select the appropri-
ate item to be stored.
ENABLE ALL
ITEMS
The ENABLE ALL ITEMS softkey marks all partial data sets.
Remote command: MMEM:SEL:ALL
DISABLE ALL
ITEMS
The DISABLE ALL ITEMS softkey deselects all partial data sets.
Remote command: MMEM:SEL:NONE
Current Settings These settings include:
• current configuration of general instrument parameters
• current measurement hardware settings
• active limit lines:
A data set may contain maximum 8 limit lines for each
window. It always contain the activated limit lines and the
de-activated limit lines used last, if any. Consequently, the
combination of the restored deactivated limit lines depends
on the sequence of use with command MMEM:LOAD.
• the activated transducer factor
• user-defined color settings
• configuration for hardcopy output
• active transducer set:
A data set may contain maximum 4 transducer factors. It
always contain the activated factors and the factors used
and de-activated last, if any. Consequently, the combination
of the restored deactivated transducer factors depends on
the sequence of use with the command MMEM:LOAD.
• peak list or final measurement results
(receiver mode)
• settings of tracking generator
(only with option R&S ESU B9)
All Limit Lines all limit lines
All Transducer all transducer factors
All Transducers all transducer
All Traces all traces which are not blanked
Source Cal Data correction data for tracking generator
(only with options R&S ESU B9 or R&S ESU B10)
Scan Channel List adds the channel lists to the list of data subsets of a save/
recall device setting.
(only with option R&S ESU K50)
Peak-Final List peak list or final measurement results
To Next Page
Loading...
