R&S ESU Series - Page 558

Operating Manual 1302.6163.12 - 03 6.119
R&S ESU Remote Control – Description of Commands
HCOPy Subsystem
HCOPy:ITEM:ALL
This command selects the complete screen to be output.
The hardcopy output is always provided with comments, title, time and date. As an alternative to the
whole screen, only traces (commands 'HCOPy:ITEM:WINDow:TRACe:STATe ON') or tables
(command 'HCOPy:ITEM:WINDow:TABLe:STATe ON') can be output.
Example: "HCOP:ITEM:ALL"
Characteristics: *RST value: -
SCPI: conform
Mode: R, A
This command is an event and therefore has no *RST value and no query.
HCOPy:ITEM:WINDow<1|2>:TABle:STATe ON | OFF
This command selects the output of the currently displayed tables.
Example: "HCOP:ITEM:WIND:TABL:STAT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A
The command HCOPy:DEVice:ITEM:WINDow<1|2>:TABle:STATe OFF as well as command
HCOPy:DEVice:ITEM:ALL enables the output of the whole screen.
HCOPy:ITEM:WINDow<1|2>:TEXT <string>
This command defines the comment text for measurement window 1 or 2 for printout, with a maximum
of 100 characters; line feed by means of character @).
Example: "HCOP:ITEM:WIND2:TEXT 'comment'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
HCOPy:ITEM:WINDow<1|2>:TRACe:STATe ON | OFF
This command selects the output of the currently displayed trace.
Example: "HCOP:ITEM:WIND:TRACe:STAT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A
The command HCOPy:ITEM:WINDow<1|2>:TRACe:STATe OFF as well as command HCOPy:
ITEM:ALL enables the output of the whole screen.