R&S ESU Series - Page 609

R&S ESU Remote Control – Description of Commands
SENSe Subsystem
6.170 Operating Manual 1302.6163.12 - 03
Example: "ESP:PRES 'WCDMA\3GPP\DL\PowerClass_31_39.xml"
'Selects the PowerClass_31_39.xml XML file in the folder
’D:\R_S\instr\sem_std\WCDMA\3GPP\DL.
"ESP:PRES?"
'Returns 'W-CDMA 3GPP (31,39)dBm DL
Characteristics: *RST value:
SCPI: device-specific
Mode: A
[SENSe<1|2>:]ESPectrum:PRESet:RESTore
This command copies the XML files from the D:\R_S.FW\\instr\sem_backup folder to the
D:\R_S\instr\sem_std folder. Files of the same name are overwritten.
This command is an event and therefore has no *RST value and no query.
The numeric suffix at SENSe<1|2> is irrelevant.
Example: "ESP:PRES:REST"
'Restores the originally provided XML files.
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
[SENSe<1|2>:]ESPectrum:RANGe<1…20>:BANDwidth[:RESolution] <numeric_value>
This command selects the resolution bandwidth (RBW) of a range in the Spectrum Emission Mask
measurement.
The numeric suffixes <1...20> specify the range. The numeric suffix at SENSe<1|2> is irrelevant.
Example: "ESP:RANG2:BAND 10E3"
'sets the RBW to 10 KHz
Characteristics: *RST value: 10 kHz
SCPI: device-specific
Mode: A
[SENSe<1|2>:]ESPectrum:RANGe<1…20>:BANDwidth:VIDeo <numeric_value>
This command selects the video bandwidth (VBW) of a range in the Spectrum Emission Mask
measurement.
The numeric suffixes <1...20> specify the range. The numeric suffix at SENSe<1|2> is irrelevant.
Example: "ESP:RANG2:BAND:VID 100E3"
'sets the VBW to 100 KHz
Characteristics: *RST value: 30 kHz
SCPI: device-specific
Mode: A