R&S ESU Series - Page 666

Operating Manual 1302.6163.12 - 03 6.227
R&S ESU Remote Control – Description of Commands
STATus Subsystem
STATus:OPERation:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:OPERation register from 1 to 0 for the
transitions of the CONDition bit.
Example: "STAT:OPER:NTR 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined value. All
PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are detected. All NTRansition parts
are set to 0, i.e. a transition from 1 to 0 in a CONDition bit is not detected. The ENABle part of the
STATus:OPERation and STATus:QUEStionable registers are set to 0, i.e. all events in these registers
are not passed on.
Example: "STAT:PRES"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:QUEStionable[:EVENt]?
This command queries the contents of the EVENt section of the STATus:QUEStionable register. The
contents of the EVENt section are deleted after the readout.
Example: "STAT:QUES?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:QUEStionable:CONDition?
This command queries the CONDition section of the STATus:QUEStionable register. Readout does not
delete the contents of the CONDition section.
Example: "STAT:QUES:COND?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:QUEStionable:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus-QUEStionable register. The ENABle
register selectively enables the individual events of the associated EVENt section for the summary bit
in the status byte.
Example: "STAT:QUES:ENAB 65535"
Characteristics: *RST value: –
SCPI: conform