R&S ESU Series - Page 668

Operating Manual 1302.6163.12 - 03 6.229
R&S ESU Remote Control – Description of Commands
STATus Subsystem
STATus:QUEStionable:POWer:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:POWer register from 0
to 1 for the transitions of the CONDition bit.
Example: "STAT:QUES:POW:PTR 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:QUEStionable:POWer:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:POWer register from 1
to 0 for the transitions of the CONDition bit.
Example: "STAT:QUES:POW:NTR 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
STATus:QUEStionable:LIMit<1|2> [:EVENt]?
This command queries the contents of the EVENt section of the STATus:QUEStionable:LIMit register.
Readout deletes the contents of the EVENt section.
Example: "STAT:QUES:LIM?"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:LIMit<1|2>:CONDition?
This command queries the contents of the CONDition section of the STATus:QUEStionable:LIMit
register.
Readout does not delete the contents of the CONDition section.
Example: "STAT:QUES:LIM:COND?"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:LIMit<1|2>:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus:QUEStionable:LIMit register. The
ENABle register selectively enables the individual events of the associated EVENt section for the
summary bit.
Example: "STAT:QUES:LIM:ENAB 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A