R&S ESU Series - Page 673

R&S ESU Remote Control – Description of Commands
STATus Subsystem
6.234 Operating Manual 1302.6163.12 - 03
STATus:QUEStionable:TRANsducer:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:TRANsducer register
from 0 to 1 for the transitions of the CONDition bit.
Example: "STAT:QUES:TRAN:PTR 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:TRANsducer:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:TRANsducer register
from 1 to 0 for the transitions of the CONDition bit.
Example: "STAT:QUES:TRAN:NTR 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEue[:NEXT]?
This command returns the earliest entry to the error queue and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error messages
defined by SCPI (cf. chapter “Error Messages”). If the error queue is empty, the error number 0, "no
error", is returned. This command is identical with the command SYSTem:ERRor.
Example: "STAT:QUE?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A