R&S ESU Series - Page 69

R&S ESU Instrument Functions
Receiver Mode
4.38 Operating Manual 1302.6163.12 - 03
Out-of-limit value for INTERACTIVE
If an out-of-limit value is detected, the R&S ESU automatically goes to the HOLD
SCAN state and starts the final measurement. The HOLD FINAL MEAS Sequence
for INTER ACTIVE submenu comes up. On completion of the final measurement,
the R&S ESU continues the prescan, and the HOLD SCAN submenu is displayed
again.
FINAL MEAS
The FINAL MEAS softkey opens the following submenu (receiver mode):
*) Dependent on the selected measurement mode AUTOMATIC FINAL or INTER ACTIVE.
PEAK SEARCH
EDIT PEAK LIST
! EDIT FREQUENCY
INSERT
DELETE
SORT BY
FREQUENCY
SORT BY DELTALIMIT
ASCII FILE EXPORT
DECIM SEP
PAGE UP
PAGE DOWN
NO OF PEAKS
PEAKS SUBRANGES
MARGIN
FINAL MEAS TIME
AUTOMATIC FINAL
INTER ACTIVE
RUN FINAL MEAS
ESH2-Z5 | ESH3-Z5 |
ENV 4200 | ENV 216 |
OFF
PRESCAN PHASES |
FINAL PHASES
!
PHASE N | PHASE L1 |
PHASE L2 | PHASE L3
150 KHZ HIGHPASS
PE GROUNDED | PE
FLOATING
RUN FINAL MEAS
! HOLD FINAL MEAS! AUTOMATIC FINAL
INTER ACTIVE
SIKP FREQUENCY*
GET MAXHOLD*
MEASURE
STOP FINAL MEAS STOP FINAL MEAS