Operating Manual 1302.6163.12 - 03 6.259
R&S ESU Remote Control – Description of Commands
TRACe Subsystem
TRACe<1|2>:POINTs LIMit, 1 to 10000
This command defines the maximum number of measurement points which are transferred in one
block after the query command TRACe? SCAN. The total amount of bytes which is transferred
depends on the number of active traces.
Example: "TRAC:POIN LIM, 8000"
'A maximum of 8000 measurement values per trace will be transferred with a single
query
Characteristics: *RST value: 1000
SCPI: device-specific
Mode: R
To Next Page
Loading...
