R&S ESU Remote Control – Description of Commands
UNIT Subsystem
6.262 Operating Manual 1302.6163.12 - 03
6.22 UNIT Subsystem
The UNIT subsystem is used to switch the base unit of setting parameters.
The numeric suffix at UNIT<1|2> selects the measurement window.
UNIT<1|2>:POWer DBM | V | A | W | DB | PCT | UNITLESS | DBPW | WATT | DBUV | DBMV | VOLT |
DBUA | AMPere | DBPT | DBUV_MHZ | DBMV_MHZ | DBUA_MHZ | DBUV_M | DBUA_M |
DBUV_MMHZ | DBUA_MMHZ
This command selects the unit for power for the selected measurement window.
DBxx_MHZ indicates the units dBxx/MHz and DBxx_MMHZ indicates the units dBxx/mMHz (the
measured level is referenced to a 1 MHz bandwidth).
Example: "UNIT:POW DBM"
'Sets the power unit for screen A to dBm.
Characteristics:
Characteristics: *RST value: DBUV
SCPI: conform
Mode: R, A
To Next Page
Loading...
