Operating Manual 1302.6163.12 - 03 6.325
R&S ESU Remote Control – Description of Commands
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
R&S
ESU
[SENSe<1|2>:]LIST:POWer[:SEQuence] <analyzer freq>,
<ref level>,
<rf att>,
<el att>,
<filter type>,
<rbw>,
<vbw>,
<meas time>,
<trigger level>,...
new function for
R&S ESU
R&S
ESU
[SENSe<1|2>:]LIST:POWer:SET <PEAK meas>,
<RMS meas>,
<AVG meas>,
<trigger mode>,
<trigger slope>,
<trigger offset>,
<gate length>
new function for
R&S ESU
R&S
ESU
[SENSe<1|2>:]LIST:POWer:STATe ON | OFF new function for
R&S ESU
FSE [SENSe<1|2>:]MIXer:BIAS <numeric_value> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:BIAS:LIMit:MIN <numeric_value> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:BIAS:LIMit[:MAX] <numeric_value> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:BLOCk ON | OFF not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:HARMonic <numeric_value> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:HARMonic:BAND A | Q | U | V | E | W | F |
D | G | Y | J
not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:HARMonic:TYPE ODD | EVEN | EODD not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:LOSS:HIGH <numeric_value> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:LOSS:TABLE <file_name> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:LOSS[:LOW] <numeric_value> not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:PORTs 2 | 3 not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:SIGNal 2 | 3 not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer:THReshold 0.1 to 100 dB not available for
R&S ESU
FSE [SENSe<1|2>:]MIXer[:STATe] ON | OFF not available for
R&S ESU
Devices Command (Sheet 37 of 47) Parameter Notes