Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
1198User Manual 1178.8520.02 ─ 01
This command activates or deactivates the frequency sweep for the selected genera-
tor.
Suffix:
<si>
.
irrelevant
<gen>
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
SOUR:EXT:FREQ:SWE ON
Activates the frequency sweep for the external generator.
SYSTem:COMPatible <Mode>
This command enables compatibility to other spectrum and signal analyzers by R&S.
Compatibility is necessary, for example, regarding the number of sweep points.
Note that this command is maintained for compatibility reasons only. Use the
SYST:LANG command for new remote control programs (see SYSTem:LANGuage
on page 1159).
Parameters:
<Mode> DEFault | FSU | FSP | FSQ | FSV
Example:
SYST:COMP FSP
14.15 Programming Examples
Some advanced programming examples for complex measurement tasks are provided
here.
Programming Examples
To Next Page
Loading...
