R&S RTO - Page 236

Mask Testing
R&S
®
RTO
220User Manual 1316.0827.02 ─ 06
2. Select the "Mask Definition" tab.
3. On the left, select the mask test for which you want to change the mask definition.
4. To add or delete a mask segment, tap the segment's row in the "Mask segments"
table and tap the required button below:
● "Insert": to add a new segment before the selected segment.
● "Append": to add a new segment at the end of the list.
● "Remove": to delete the selected mask segment from the list.
5. To add, delete, or move a point of a segment:
a) Select the segment in the "Mask segments" table.
b) Select the point in the "Definition of segment" table.
c) To add or delete the selected point, use the buttons below the table.
● "Insert": to add a new point before the selected point.
● "Append": to add a new point at the end of the list.
● "Remove": to delete the selected point from the list.
d) To move the selected point, change the X- and Y-values.
To rescale and move a mask segment
The settings mentioned here are described in detail in chapter 8.3.2.1, "Mask Definition:
User Mask", on page 227.
1. Press the MASKS key on the front panel.
2. Select the "Mask Definition" tab.
3. On the left, select the mask test for which you want to change the mask definition.
4. Select the required segment in the "Mask segments" table.
Working with Masks