R&S RTO - Page 563

Remote Control
R&S
®
RTO
547User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
<n> 1..2
Selects the source number.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
MEASurement<m>:
AMPTime:PTCount <PulseCount>
Sets the number of positive pulses for the pulse train measurement. It measures the
duration of N positive pulses from the rising edge of the first pulse to the falling edge of
the N-th pulse.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<PulseCount> Range: 1 to 2147483647
Increment: 1
*RST: 1
MEASurement<m>:AMPTime:ESLope <EdgesSlope>
Sets the edge direction to be counted: rising edges, falling edges, or both. The setting is
only relevant for edge count measurement on digital channels (MEASurement<m>:MAIN
EDGecount or MEASurement<m>:ADDitional EDGecount,ON).
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<EdgesSlope> POSitive | NEGative | EITHer
*RST: POSitive
MEASurement<m>:AMPTime:CSLope <SetupHoldClockSlope>
Sets the edge of the clock from which the setup and hold times are measured.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Command Reference