R&S RTO6 - Page 49

Operating the instrument
R&S
®
RTO6
49Getting Started 1801.6670.02 ─ 03
tions, like cursor and histogram measurements are performed on the selected
waveform. All waveform-specific settings are applied to the selected waveform
of the selected diagram.
The vertical [Position] and the [Scale] knobs are illuminated with the color of
the selected waveform.
In Figure 6-1, C2 is the selected waveform: The frame of the diagram and the
signal icon are highlighted.
●
Minimized:
The waveform is shown as real-time signal view in its signal icon.
To switch a waveform on
A channel waveform is activated as soon as you connect the probe. You can
switch it on and off according to your needs.
► Choose one of the following ways:
● Press the channel key.
● In the "Vertical" dialog box, select the channel and tap "Channel" > "On".
The waveform is now active, selected, and is shown in the diagram.
To select a waveform
► Choose one of the following ways:
● Tap the waveform in the waveform diagram.
● To select a channel, reference, or math waveform, press the correspond-
ing key.
● Tap the signal icon.
Note: Zoom waveforms in zoom diagrams cannot be selected.
To minimize a waveform
► Choose on of the following ways:
● Tap the "Minimize" icon in the upper right corner of the waveform's signal
label in the signal bar.
● Drag the waveform from the diagram to the signal bar.
The waveform disappears from the diagram and the minimized signal view is
shown in the signal icon.
► To set the waveform back to its previous diagram immediately, use "Undo".
Working with waveforms