R&S RTO6 - Toolbar

Operating the instrument
R&S
®
RTO6
51Getting Started 1801.6670.02 ─ 03
The diagram configuration is deleted when you use [Preset] and *RST.
To arrange a waveform using the SmartGrid
You can arrange waveforms in one of the existing diagrams, or in a new diagram.
1. Drag the signal icon to the diagram area, and move it around.
The Rohde & Schwarz SmartGrid appears and a blue area shows where the
waveform will be placed.
2. Drop the waveform in the target area.
The waveform appears in an existing or in a new diagram, and it is selected
for further actions.
3. To change the size of a diagram, tap the handle between two diagram frames
and drag it to the required position.
6.6 Toolbar
The toolbar provides direct access to important control and measurement func-
tions.
Toolbar