R&S RTO6 - Page 1083

Jitter analysis and clock data recovery
R&S
®
RTO6
1083User Manual 1801.6687.02 ─ 05
Serial
standard
Nom. bit
rate
Bandwidth Rel. bandwidth Order Damping
Fibre
Channel 4x
4 Gbps 1667 2.4 MHz 1st -
HDMI 1.2 1.32 Gbps 1667 791.84 kHz 1st -
HDMI 1.4 3.4 Gbps 1667 2.04 MHz 1st -
HDMI 2.0 4.8 Gbps 1667 2.88 MHz 1st -
PCIe Gen
1
2.5 Gbps 1667 1.5 MHz 2nd 0.7
PCIe Gen
2
5 Gbps 1000 5 MHz 2nd 0.7
SATA Gen
1 (1/500)
1.5 Gbps 500 3 MHz 2nd 0.7
SATA Gen
1 (1/1667)
1.5 Gbps 1667 899.82 kHz 2nd 0.7
SATA Gen
1
1.5 Gbps 1667 899.82 kHz 2nd 0.7
SATA Gen
2 (1/500)
3 Gbps 500 6 MHz 2nd 0.7
SATA Gen
2 (1/1667)
3 Gbps 1667 1.8 MHz 2nd 0.7
SATA Gen
2
3 Gbps 1667 1.8 MHz 2nd 0.7
SATA Gen
3 (1/500)
6 Gbps 500 12 MHz 2nd 0.7
SATA Gen
3 (1/1667)
6 Gbps 1667 3.6 MHz 2nd 0.7
SATA Gen
3
6 Gbps 1667 3.6 MHz 2nd 0.7
SAS Gen 1 3 Gbps 1667 1.8 MHz 1st -
SAS Gen 2 6 Gbps 1667 3.6 MHz 1st -
XAUI 3.75 Gbps 1667 2.25 MHz 1st -
Remote command:
ADVJitter<m>:SIGNal:
SERStandard on page 2491
Signal Type
Select, if the analyzed signal is a data or clock signal.
Remote command:
ADVJitter<m>:SIGNal:TYPE on page 2485
Quick start analysis
Starts a quick advanced jitter analysis.
Advanced jitter and noise (option R&S R
T
O6- K133/K134)