R&S RTO6 - Page 1542

Remote control commands
R&S
®
RTO6
1542User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
MEASurement<m>:PROTocol:FLDValue:FLD <FieldName>
Sets the type of field for the frame of the field value protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<FieldName>
MEASurement<m>:PROTocol:FLDValue:FRM <FrameName>
Sets the type frame for the field value protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:FLDValue:TRCK <FieldName>
Sets the field to be tracked value of the frame for the field value protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FieldName>
MEASurement<m>:PROTocol:FLDValue:VAL <FieldValIdV
al>
Sets the field value of the frame for the field value protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FieldV
alIdVal>
Usage: Asynchronous command
Automatic measurements