R&S RTO6 - Page 1583

Remote control commands
R&S
®
RTO6
1583User Manual 1801.6687.02 ─ 05
MTESt:REMove <MaskT
estName>
Deletes the mask test definition with the specified name.
Setting parameters:
<MaskT
estName> String with the name of the mask test
Usage: Setting only
Asynchronous command
MTESt[:STATe] <MaskTestName>,<State>
MTESt[:ST
ATe]? <MaskTestName>
Activates and deactivates the mask test. If the acquisition is running, the test starts
immediately. Otherwise, the test starts when acquisition is started.
The testing is stopped when acquisition is stopped, also due to the MTESt:
ONViolation:STOP command, or if MASK[:STATe] is set to "OFF".
The coommand needs *OPC command synchronisation.
Parameters:
<State> ON | OFF
*RST: OFF
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Example:
MTEST:STAT 'MyMask', ON; *OPC?
See Chapter 24.3.3.1, "Creating a user mask", on page 1265
Usage: Asynchronous command
MTESt:SHOW <State>
Switches the display of all mask segments on or off.
Parameters:
<State> ON |
OFF
*RST: ON
Usage: Asynchronous command
MTESt:RST
Clears all totals and results in all "Mask T
est" result boxes.
Usage: Event
Asynchronous command
Mask testing