R&S RTO6 - Page 1596

Remote control commands
R&S
®
RTO6
1596User Manual 1801.6687.02 ─ 05
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Usage: Asynchronous command
MTESt:ONViolation:REPort <MaskTestName>,<Report>
MTESt:ONV
iolation:REPort? <MaskTestName>
Creates and saves a report of the current settings and results.
Parameters:
<Report> NOACtion | SUCCess | VIOLation
See Chapter 24.4.5, "Event parameter", on page 1286
*RST: NOACtion
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Usage: Asynchronous command
MTESt:ONViolation:TRIGgerout <MaskTestName>,<T
riggerOutPulse>
MTESt:ONViolation:TRIGgerout? <MaskTestName>
Creates a trigger out pulse on mask violation or successful completion of the test cycle.
Parameters:
<TriggerOutPulse> NOACtion | SUCCess | VIOLation
*RST: NOACtion
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Usage: Asynchronous command
MTESt:ONViolation:RUNexec <MaskTestName>,<RunExecutable>
MTESt:ONV
iolation:RUNexec? <MaskTestName>
Starts an external application if the command is set to VIOLation or SUCCess.
Use the following commands to set up the application:
●
EXECutable:NAME on page 1668
●
EXECutable:PARameter on page 1669
●
EXECutable:WDIRectory on page 1669
Parameters:
<RunExecutable> NOACtion | SUCCess | VIOLation
See Chapter 24.4.5, "Event parameter", on page 1286
*RST: NOACtion
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
Mask testing