R&S RTO6 - Page 1923

Remote control commands
R&S
®
RTO6
1923User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:SENT:PULSeerror <SearchName>,<CalibPulseError>
SEARch:TRIGger:SENT
:PULSeerror
? <SearchName>
Enables the search for calibration pulse errors.
To initially enable the search for an error event, set SEARch:TRIGger:SENT:ERRor
to ON.
Parameters:
<CalibPulseError> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:PPERioderror <SearchName>,<PulsePeriodErr>
SEARch:TRIGger:SENT:PPERioderror?
<SearchName>
Enables the search for pulse period errors.
To initially enable the search for an error event, set SEARch:TRIGger:SENT:ERRor
to ON.
Parameters:
<PulsePeriodErr> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:IRFLength <SearchName>,<IrregularFrmLen>
SEARch:TRIGger:SENT:IRFLength? <SearchName>
Enables the search for irregular frame length errors in transmission sequences.
This error type is relevant if pause pulse mode is set to constant frame length.
T
o initially enable the search for an error event, set SEARch:TRIGger:SENT:ERRor
to ON.
Parameters:
<IrregularFrmLen> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:FORMerror <SearchName>,<FormError>
SEARch:TRIGger:SENT:FORMerror
? <SearchName>
Enables the search for format errors in serial messages.
Protocols