R&S RTO6 - Page 1969

Remote control commands
R&S
®
RTO6
1969User Manual 1801.6687.02 ─ 05
TRIGger<m>:MILStd:STATus:INSTrument <InstFlag>
T
riggers on the state of the instrumentation bit of the status word if
TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<InstFlag> ONE | ZERO | DC
*RST: ZERO
TRIGger<m>:MILStd:STATus:MERRor <MessageError>
Triggers on the state of the message error bit of the status word if
TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<MessageError> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:SREQuest <ServiceRequest>
Triggers on the state of the the service request bit of the status word if
TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<ServiceRequest> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:SUBSystem <SubsystemFlag>
Triggers on the state of the subsystem flag bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<SubsystemFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:TERMinal <TerminalFlag>
T
riggers on the state of theterminal flag bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<TerminalFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:TPSPecifier <TypeSpecifier>
Sets the sync impulse/ word type to be triggered on.
Protocols