R&S RTO6 - Page 1994

Remote control commands
R&S
®
RTO6
1994User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:ARINc:LABel:CONDition <SearchName>,<LabelOperator>
SEARch:TRIGger:ARINc:
LABel:CONDition? <SearchName>
SEARch:TRIGger:ARINc:
DATA:CONDition <SearchName>,<DataOperator>
SEARch:TRIGger:ARINc:DATA:CONDition? <SearchName>
Set the condition for the label or data, respectively. You can define an exact value or a
value range
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIG
ger:ARINc:...:MIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range. withTRIGger<m>:ARINc:LABel:MIN and
TRIGger<m>:ARINc:LABel:MAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:ARINc:LABel:MIN <SearchName>,<LabelMin>
SEARch:TRIGger:ARINc:LABel:MIN? <SearchName>
SEARch:TRIGger:ARINc:
DATA:MIN <SearchName>,<DataMin>
SEARch:TRIGger:ARINc:DATA:MIN? <SearchName>
Specifies a label or data bit pattern, or sets the the start value of a pattern range.
Parameters:
<DataMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
String parameter
SEARch:TRIGger:ARINc:LABel:MAX <SearchName>,<LabelMax>
SEARch:TRIGger:ARINc:LABel:MAX?
<SearchName>
SEARch:TRIGger:ARINc:DATA:MAX <SearchName>,<DataMax>
SEARch:TRIGger:ARINc:DATA:MAX? <SearchName>
Set the end value of a label or data pattern if the condition is set to INRange or
OORange.
Parameters:
<DataMax> Numeric or string pattern, see SEARch:TRIGger:ARINc:
LABel:
MIN
Protocols