R&S RTO6 - Page 2266

Remote control commands
R&S
®
RTO6
2266User Manual 1801.6687.02 ─ 05
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:DPHY:ESDTa:CONDition <SearchName>,<Format>
SEARch:TRIGger:DPHY
:ESDT
a:CONDition? <SearchName>
Set the condition for the escape mode data value. You can define an exact value or a
value range.
Parameters:
<Format> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:
TRIGger:DPHY:
ESDTa:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:DPHY:ESDTa:MIN and
SEARch:TRIGger:DPHY:ESDTa:MAX.
OFF | ANY
Any pattern is detected.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:DPHY:ESDTa:MAX <SearchName>,<LPEscapeDataMax>
SEARch:TRIGger:DPHY:ESDT
a:MAX? <SearchName>
Sets the the end value of a escape mode data type range if SEARch:TRIGger:DPHY:
ESDTa:CONDition is set to INRange or OORange.
Parameters:
<LPEscapeDataMax>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:DPHY:ESDTa:MIN <SearchName>,<LPEscapeDataMin>
SEARch:TRIGger:DPHY:ESDT
a:MIN? <SearchName>
Specifies an escape mode data bit pattern, or sets the the start value of a pattern
range.
Parameters:
<LPEscapeDataMin>
Protocols