Remote control commands
R&S
®
RTO6
2358User Manual 1801.6687.02 ─ 05
TRIGger<m>:PCIE:TLP:MERW <MemR
W>
Sets the read/ write type to be triggered on for the transaction layer type trigger
.
Parameters:
<MemRW> ANY | READ | WRITE
*RST: ANY
TRIGger<m>:PCIE:TLP:MSGC <TLPMessageCode>
Sets the message code to be triggered on for the transaction layer type trigger.
Parameters:
<TLPMessageCode>
8-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:MSGR <MsgRouting>
Sets the message routing type to be triggered on for the transaction layer type trigger.
Parameters:
<MsgRouting>
ANY | ROOTCOMPLEX | ADDRESS | DEVICEID | DEViceid |
BROADCAST | LOCAL | GA
THERED
DEVICEID = DEViceid
*RST: ANY
TRIGger<m>:PCIE:TLP:ORDE <Ordering>
Sets the ordering type to be triggered on for the transaction layer type trigger.
Parameters:
<Ordering>
ANY | STRONG | RELAX
*RST: ANY
TRIGger<m>:PCIE:TLP:REID <TLPRequesterID>
Sets the requester ID to be triggered on for the transaction layer type trigger.
Parameters:
<TLPRequesterID>
16-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:SNOO <Snoop>
Sets the snoop state to be triggered on for the transaction layer type trigger.
Protocols
To Next Page
Loading...
