R&S RTO6 - Page 244

Waveform analysis
R&S
®
RTO6
244User Manual 1801.6687.02 ─ 05
X range ← Position/Range
Defines the width of the zoom area.
Remote command:
LAYout:
ZOOM:HORZ:
ABSolute:SPAN on page 1440
LAYout:ZOOM:HORZ:RELative:SPAN on page 1441
SEARch:RESDiagram:HORZ:ABSolute:SPAN on page 1635
SEARch:RESDiagram:HORZ:RELative:SPAN on page 1636
Y position ← Position/Range
Defines the y-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:VERTical:ABSolute:POSition on page 1443
LAYout:ZOOM:VERTical:RELative:POSition on page 1444
SEARch:RESDiagram:VERT:ABSolute:POSition on page 1636
SEARch:RESDiagram:VERT:RELative:POSition on page 1637
Y range ← Position/Range
Defines the height of the zoom area.
Remote command:
LAYout:ZOOM:VERTical:RELative:SPAN on page 1445
LAYout:ZOOM:VERTical:ABSolute:SPAN on page 1443
SEARch:RESDiagram:VERT:ABSolute:SPAN on page 1636
SEARch:RESDiagram:VERT:RELative:SPAN on page 1637
X mode
Defines whether absolute or relative values are used to specify the x-axis values.
Remote command:
LAYout:ZOOM:HORZ:MODE on page 1439
SEARch:RESDiagram:HORZ:MODE on page 1635
Y mode
Defines whether absolute or relative values are used to specify the y-axis values.
Remote command:
LAYout:ZOOM:VERTical:MODE on page 1442
SEARch:RESDiagram:VERT:MODE on page 1637
Position coupling
Enables or disables the position coupling of coupled zooms. If position coupling is
enabled and you move one zoom area, the other coupled zoom areas are moved, too,
and keep their distance.
Remote command:
LAYout:ZOOM:POSCoupling on page 1439
Full height
Uses the full diagram height for the zoom area. Only horizontal zoom settings can be
changed.
Zoom