R&S RTO6 - Page 2475

Remote control commands
R&S
®
RTO6
2475User Manual 1801.6687.02 ─ 05
Parameters:
<RecordLength> Range: 1 to 10E+6
Increment: 2
*RST: 100000
Default unit: pts
Usage: Asynchronous command
CHANnel<m>:IQ:CFRequency <IQCarrierFreq>
Sets the carrier frequency of the modulated RF signal or of the complex signal in IF
range.
Prerequisites:
●
CHANnel<m>:IQ:INPType
on page 2473 is set to REAL
or:
●
CHANnel<m>:IQ:INPType on page 2473 is set to COMPlex and CHANnel<m>:
IQ:INPMode on page 2473 is set to RFIF
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<IQCarrierFreq> Range: 10E-3 to 10E+9
Increment: 100
*RST: 1E+6
Default unit: Hz
Usage: Asynchronous command
CHANnel<m>:IQ:SBRF <IQSidebandRF>
Defines the frequency position of the RF spectrum in the input signal: normal or
inverse. The position is important for correct down-conversion and filtering.
Prerequisite: CHANnel<m>:
IQ:INPType on page
2473 is set to REAL
For details, see "Sideband (real input)" on page 1063
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<IQSidebandRF> INVerse | NORMal
*RST: NORMal
Usage: Asynchronous command
I/Q software interface (option R&S RT
O6-K11)