Remote control commands
R&S
®
RTO6
2491User Manual 1801.6687.02 ─ 05
ADVJitter<m>:SIGNal:GATE:ZDIagram <ZoomT
ype>
Sets the zoom the gate is coupled to, if
ADVJitter<m>:SIGNal:GATE:COUPling is
set to ZOOM.
Suffix:
<m>
.
1..2
Parameters:
<ZoomType>
ADVJitter<m>:SIGNal:GATE:STATe <State>
Enables the gating setup for the advanced jitter analysis.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:SIGNal:SERStandard <SerStandardType>
Sets the serial standard. Set
CUSTOM to adjust the bit rate and the bandwidth manually.
The serial standards are available only if the instrument is able to support its maximum
nominal bit rate.
Suffix:
<m>
.
1..2
Parameters:
<SerStandardType> CUSTOM | USB20 | USB31GEN1 | USB31GEN2 |
DISPPORT1
1 | DISPPORT12 | FIBCHAN1 | FIBCHAN2 |
FIBCHAN4 | FIBCHAN8 | FIBCHAN16 | HDMI12 | HDMI14 |
HDMI20 | PCIGEN1 | PCIGEN2 | PCIGEN3 | PCIGEN4 |
SATAGEN1500 | SATAGEN11667 | SATAGEN1 |
SATAGEN2500 | SATAGEN21667 | SATAGEN2 |
SATAGEN3500 | SATAGEN31667 | SATAGEN3 | SASGEN1 |
SASGEN2 | SASGEN3 | TB10G | XAUI | CUSTOM | USB20 |
USB31GEN1 | DISPPORT11 | DISPPORT12 | FIBCHAN1 |
FIBCHAN2 | FIBCHAN4 | HDMI12 | HDMI14 | HDMI20 |
PCIGEN1 | PCIGEN2 | SATAGEN1500 | SATAGEN11667 |
SATAGEN1 | SATAGEN2500 | SATAGEN21667 | SATAGEN2 |
SATAGEN3500 | SATAGEN31667 | SATAGEN3 | SASGEN1 |
SASGEN2 | XAUI
*RST: CUSTOM
Usage: Asynchronous command
Jitter analysis and clock data recovery
To Next Page
Loading...
