R&S RTO6 - Page 354

Measurements
R&S
®
RTO6
354User Manual 1801.6687.02 ─ 05
MEASurement<m>:PROTocol:F2FRame:VALFrom on page 1541
MEASurement<m>:
PROTocol:
F2FRame:VALTo on page 1541
Trigger to frame
Opens a dialog to set up the parameters for the trigger to frame measurement.
The types of available frames are depending on the enabled protocol, see Table 8-11.
"Direction"
Selects the direction for the measurement, from the trigger to the next
frame (start),
"Frame"
Selects the type of frame.
"Field"
Selects the type of field.
"Value"
Sets a value for the selected field.
Remote command:
MEASurement<m>:PROTocol:
T2FRame:DIRection on page 1544
MEASurement<m>:PROTocol:T2FRame:FLD on page 1544
MEASurement<m>:PROTocol:T2FRame:FRM on page 1544
MEASurement<m>:PROTocol:T2FRame:VALue on page 1545
Field value
Opens a dialog to set up the parameters for the field value measurement. You can first
identify a frame with specific field value and then track a selected field of this frame.
The types of available frames and fields depend on the enabled protocol, see
Table 8-11.
If a label list is loaded and enabled for the protocol, sometimes there are defined calcu-
lations and formatting for the displayed field value. In this case, the measurement dis-
plays the value according to the definition in the label list.
"Frame"
Selects the type of frame.
"Field"
Selects the type of field.
Automatic measurements